CMC PT-130
CMC PT-130

Опыт, комфорт и улучшенная производительность СМС РТ-130 с датчиком

This unit «Includes» the Trim Gauge Option
The CMC PT-130 Tilt & Trim incorporates a 6″ setback which enhances Boat Stability and enables the prop to get a better «bite» at a higher prop setting. With the touch of a switch you can raise your motor to protect your prop from damage and your back from strain. The PT130 Tilt & Trim has 20 degrees of trim and 90 degrees of trim and tilt. It allows to tuck your motor in to get your boat on plane smoother and faster. When you’re underway, you can change the angle of your motor to obtain the best performance for your load and water conditions. It gives you a more stable ride, increases top end speed, allows more prop clearance, and better fuel economy.

Superior Construction
The PT-130 Tilt and Trim, is a computer aided design, our commitment to quality and manufacturing excellence is evident in every product we make. The PT- 130 is constructed of 1/2″ 6061 T6 alloy aluminum extrusions and fastened with stainless steel fasteners for maximum strength and durability. No molded aluminum which has less resistance to stress. This system is made of 100% non-ferrous material which makes it impervious to saltwater and freshwater.

Most Powerful On The Market
The CMC PT-130 is actuated with a totally waterproof marine electric hydraulic System that is rated OVER 7800 lbs. OF THRUST! Over 40% more powerful than other brands. It is also more impervious to saltwater and freshwater than others because it is made of 100% non ferrous materials. Our hydraulic system is completely sealed and submersible and runs without worry of water damage. No electromechanical ball screw !

Ideal For Any Type Of Boat
The CMC PT130 will fit on virtually any type of boat and outboard motor. The PT-130 along with the optional trim gauge makes it very easy to know the exact angle of your motor. It’s especially convenient on pontoon boats. Rated for 10H.P. through 130H.P. motors, it fits standard B.I.A. bolt pattern motors without drilling holes. A convenient adapter kit is available for motors that are mounted with transom clamps.

Features:
Rated for 130 H.P. and Smaller Motor
6″ Set Back to Enhance Boat Stability and Performance
20° of Trim and a Total of 90° of Tilt and Tri
1/2″ 6061 T6 Extruded Aluminum Construction with Stainless Steel Fastener
Electric Hydraulic Actuator Rated at 7853 lbs. of Thrust
Standard B.I.A. Bolt Hole Pattern
Convenient Adapter Kit Available for Clamp-on Motors (sold seperate, see accessories)

Includes:
Main Tilt & Trim Unit
Main Wiring Harness
Tilt & Trim Gauge
Gauge Wiring Harness
Tilt & Trim Switch
Sending Unit (pre-mounted on the main unit)
Stainless Steel Mounting Hardware
Detailed Installation/Owners Manual (can be previewed below)